How do I roll an Inside-Out Joint?

1. Pick your favorite papers. You may want to use a heavy paper at first, I find its easier to tuck thick paper under the bud. It is important that you can get it good and tight the first time, as you will not be able to wrap the paper around the joint again making it tight.



2. Start off with the paper gummy side down, with the gum at the bottom. Fold part of the gum up so that you can tuck it in easier. Fold the paper in half. With most papers you will be folding against the crease. Open it back up, and fill it with bud.


3. Now, you should start with your gummy side facing you. Roll the paper between your fingers as you would a normal joint, making the bud compact and even across the joint.

4. Tuck your gummy side under your bud, making sure that is stays flat and does not fold.. It is very important that it is flat against the paper you've tucked it under. Bring the top non-gummed side over the joint.

5. Hopefully you are left with something like this. Notice you can see the gummy side of the paper (indicated by the red area) through the rest of the paper. Your not done yet! Wet either your fingertips or your tongue enough that you can moisten this paper thoroughly, and get the glue to stick. This one side will be quite wet, but that's okay. Move a lighter across the wet side of the joint quick enough so it doesn't burn, but slow enough that it dries.

6. You are left with anywhere from half to 3/4 of your original paper. Just cut/tear/burn the remainder off, twist the ends, and your through.